NEW CAB NOW AVAILABLE!
We have updated our Yukon cab design for the models shown above. This cab is not ROPS certified, but sits in front of the existing, un-modified factory ROPS. Included in this cab is an electric wiper on the safety glass windshield. This cab can be configured with your choice of hard sides (with sliding windows) or hard/soft side panels. The left hand door is hinged with a secure latching handle. The right hand side of the cab is fixed, but can be configured with a hard sliding glass window or a soft clear vinyl curtain. Rear of cab can be soft or hard as well. Your cab can be custom configured below with these and other optional accessories.
Special Fit-up Notes: This cab will fit bare tractors or tractors with a KL130 factory loader. The rear panel of cab is removable if desired to better accomodate backhoe operation on backhoe equipped tractors. NOTE: Bare Tractors will require the Optional Front Mount Shim Kit, part number 10-2920S.
Cab height is approximately 67 inches high, measured from the platform floor, 67-3/4" to the top of the studs on the basic black roof, and 69" to the top of the ABS roof, if so equipped. The studs may be removed from the basic steel roof, if the ABS roof is not being purchased. The top of the cab sits below the top of the folding ROPS, although the ROPS must remain upright in order to mount the cab to the tractor.
Installation Time: (Allow extra time for optional accessories)
Dealer: 4-6 Hours Consumer: 8-10 Hours
The optional Air Conditioning (P/N 600-4242) accessory offered below is for reference only, and is not a guarantee that this accessory fits and works with all tractor and engine combinations. Customer is responsible for ensuring sufficient engine compartment space and engine HP is available for mounting and powering the A/C compressor for their particular tractor and engine configuration.