Newly Updated Door Assembly that fits the 75XT, 85XT, 90XT, 95XT Series II models.
Door assembly consists of a steel framed removable hinged door with either TINTED SAFETY GLASS OR LEXAN, pantograph style electric wiper assembly, and skylight panel. DOES NOT INCLUDE SLIDING WINDOWS. Door Assemblies also include the hinge post, latch post, and header (header may be priced separately on some models and is different for the 400 series versus the XT series).
Please refer to service parts for this item if only the door (with or without glass and/or hardware) is needed for service replacement purposes (Lost or Damaged door for example).
Optional soft or hard side panels are also available at extra cost for this door assembly to completely enclose the operator's station. See below to custom configure your enclosure with these and other optional accessories.
Special Fit-up Notes: Serial number of XT Series skidsteer is required. This door assembly only fits Series 2 XT units with serial numbers higher than the serial breaks as follows: 75XT - JAF0318922, 85XT - JAF0352234, 90XT - JAF0320050, 95XT - JAF0311357. Refer to our Series 1 door / side panel kit if your unit has a serial number lower than the serial breaks listed here. Enclosure side panels will not fit if skidsteer is equipped with 4-IN-1 Bucket accessory. Heater mounts between operators feet in Case 75XT, 85XT, 90XT. Heater mounts behind operators seat in Case 95XT
Installation Time - ALL STEEL ENCLOSURE:
Dealer: 5-8 Hours Consumer: 7-10 Hours
Installation Time - SOFT SIDE ENCLOSURE:
Dealer: 4-6 Hours Consumer: 6-8 Hours
Installation Time - DOOR ASSEMBLY ONLY:
Dealer: 3-4 Hours Consumer: 4-5 Hours